Licensing the software
For the following products, you need to transfer the product-specific license key with the Automation License Manager (ALM) before commissioning:
WinCC RT Advanced incl. PowerTag
CPU 1505SP T/TF
No license key is required to operate the S7‑1500 Software Controller CPU 1505SP (F).
Requirements
Initial commissioning was successfully completed.
Windows 10 IoT Enterprise (64-bit LTSC 2021) is started.
The extended write filter UWF must be deactivated on the CPU 1515SP PC2.
Transferring license keys with local configuration
The Automation License Manager is pre-installed on the CPU 1515SP PC2.
Open the software using the icon on the desktop or a menu command.
In the Windows start bar, select Start > Siemens Automation > Automation License Manager.
Follow the instructions of the Automation License Manager.
Transferring license keys via programming device/PC
The Automation License Manager is pre-installed on a programming device/PC with STEP 7 and the CPU 1515SP PC2.
Connect the CPU 1515SP PC2 to a programming device/PC.
Connect the supplied USB stick to the programming device/PC.
Select the menu command Start > Siemens Automation > Automation License Manager.
Select the menu command Edit > Connect computer and enter the IP address of the CPU 1515SP PC2.
if the option "Forbid license keys transfer from local computer" is disabled on the source computer, drag the license keys from the USB stick to the system partition C: of the CPU 1515SP PC2.
Backing up license keys for restore and repair
Loss of license keys
A SIMATIC license key cannot be copied or duplicated. No more license key copies exist on the USB stick once you have dragged the license keys from the USB stick to your CPU 1515SP PC2.
Secure your purchased license keys before restoring the delivery state (Restore) or in the case of repair. To do this, move the license keys to a USB stick and keep this stick in a safe place.
If an error occurs on your license keys on the CPU 1515SP PC2, please contact your Siemens representative. Make sure to have the "Certificate of License" (CoL) to hand.
Reference
For additional information on licenses, refer to the Automation License Manager manual. You can find the manual on the CPU 1515SP PC2 under Start > All Programs > Siemens Automation > Documentation and on the Internet.
You can find additional information on the UWF write filter in the section Data loss in the event of unexpected shutdown.