|
ErrorID |
Validity |
Description |
Remedy |
|
|---|---|---|---|---|
|
TO1) |
Kin2) |
|||
|
16#8070 |
✓ |
- |
Illegal value for leading value shift |
Specify a permissible value for the leading value shift for parameter "PhaseShift". |
|
16#8071 |
✓ |
- |
The job cannot be executed because the axis is not in position-controlled mode. |
Activate position-controlled mode. |
|
16#8074 |
✓ |
- |
The job cannot be executed because a "MC_Home" job is active. |
During active or passive homing, an encoder switchover is rejected. Wait until the "MC_Home" job is complete. Restart the job. |
|
16#8075 |
✓ |
- |
The job cannot be executed because no synchronization operation is active on the axis. |
Switch on the synchronous operation function. Restart the job. |
|
16#8076 |
✓ |
- |
The job cannot be executed because synchronization is being simulated at the specified axis. |
End the simulation of the synchronous operation. Restart the job. |
|
16#8077 |
✓ |
- |
The job cannot be executed because no "MC_GearInPos" or "MC_GearIn" job is waiting or active. |
Switch on the synchronous operation function. Restart the job. To desynchronize a camming, use the Motion Control instruction "MC_CamOut". |
|
16#8078 |
✓ |
- |
The job cannot be executed because no "MC_CamIn" job is waiting or active. |
Switch on the camming function. Restart the job. To desynchronize gearing, use the Motion Control instruction "MC_GearOut". |
|
16#8079 |
✓ |
- |
The job cannot be executed because a velocity gearing with "MC_GearInVelocity" is active. |
A job to offset the leading or following value is only applicable during an active gearing or camming. |
|
Following axis is in non-position-controlled operation. Stop velocity gearing and restart "MC_GearInPos" job or "MC_CamIn" job. |
||||