Options in the parameter settings for the Industrial Ethernet interface
When setting parameters for the Industrial Ethernet interface, you have the following options:
-
Parameters dependent on the operating system
The Industrial Ethernet interface has parameters that are set in the operating system and are valid for all connected devices. These parameter settings are only displayed here, they can, however, be changed in the network settings of the operating system.
-
Parameters that can be set in the software
Note
Note that changes to interface parameters have a direct influence on the operating system and the programming device / PC. Remember that some parameter settings can only be changed if you have adequate user rights.
Parameters for the Industrial Ethernet interface
The following table contains an overview of the parameters of the Industrial Ethernet interface that are set by the operating system and can be changed by the user.
|
Parameter settings that cannot be changed |
Parameters that can be set |
|---|---|
|
MAC address |
Fast acknowledge at the IE-PG access and for TCP/IP |
|
DHCP server activated/deactivated |
Timeout at the IE-PG access and for TCP/IP |
|
APIPA activated/deactivated |
LLDP |
|
IP address |
Additional, dynamic IP addresses for the network adapter |
|
Subnet mask |
- |
|
DNS addresses |
- |
|
DHCP addresses |
- |